Releasing Switch Unit From The Rack; Removing Mounting Brackets From - Lenovo ThinkAgile CP Part Replacement And Component Maintenance Procedures

Step 2. Disconnect all external cables.
Step 3. Loosen and remove M6 screws, washers, and clip nuts (or cage nuts) to release the switch unit
from the rack.
Figure 56. Releasing switch unit from the rack
Step 4. Slide the switch unit out of the rack.
Step 5. Loosen and remove the M4 screws attaching the mounting bracket on each side of the switch.
Figure 57. Removing mounting brackets from switch
Install the replacement NE0152T unit by completing the steps in "" on page .
90
ThinkAgile CP Part Replacement and Component Maintenance Procedures