To install the ThinkSystem NE0152T RackSwitch in a standard equipment rack, complete the following
steps:
Step 1.
Locate, record, and retain the product switch information in order to configure and register your
product.
Step 2.
Attach a mounting bracket (item 1 in the illustration) to each side of the switch with M4 screws (item
2). Torque the screws to approximately 2.0 newton‐meters (Nm) ± 0.1 Nm (17.7 inch‐pounds).
Figure 25. Attaching mounting brackets to switch
Step 3.
From the front, slide the switch into the rack at the desired height.
Step 4.
Secure the switch unit to the rack posts with M6 screws (item 3 in illustration), washers (item 6), and
either clip nuts (item 4) or cage nuts (item 5). Torque the screws to approximately 5.7 Nm ± 0.1 Nm
(50 inch‐pounds).
Figure 26. Securing switch to rack posts
44
Lenovo ThinkAgile CP Hardware Installation Guide