Hot-Swap Power Supply Installation - Lenovo ThinkAgile CP Part Replacement And Component Maintenance Procedures

Before installing a hot-swap power supply:
1. Touch the static-protective package containing the new hot-swap power supply to any unpainted
surface on the outside of the storage.
2. Take the new hot-swap power supply out of the package and place it on a static-protective surface.
Procedure performed by: Customer or field service
To install a hot-swap power supply, complete the following steps:
Step 1. Ensure that the handle is in the open position.
Step 2. Press the release tab down, and slide the new hot-swap power supply into the bay at the same
time until the release latch clicks into place.
Figure 38. Hot-swap power supply installation (1)
Step 3. Close the handle.
.
Chapter 6 Storage block maintenance procedures
65