Hot-Swap Power Supply Removal - Lenovo ThinkAgile CP Part Replacement And Component Maintenance Procedures

Figure 14. Hot-swap power supply removal
Step 1. Disconnect the power cord from the connector on the back of the power supply.
Step 2. Press and hold the orange release tab to the left.
Step 3. Grasp the handle and pull the power supply out of the bay.
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install a hot-swap power supply
Use this information to install a hot-swap power supply.
Chapter 3 "Read
the
Installation
Guidelines" on
page 9
To avoid possible danger, read and follow the following safety statement.
• S001
28
ThinkAgile CP Part Replacement and Component Maintenance Procedures
"ATTENTION:
Static Sensitive Device
Ground package before
opening" on page 11