Specifications - Pulsar PSDCB09129C Manual

www.pulsar.pl

1.4 Specifications:

- electrical parameters (tab.3)
- mechanical parameters (tab.4)
- operation safety (tab.5)
- operating parameters (tab.6)
Electrical parameters (tab. 3)
Mains supply
Current up to
Supply power
Efficiency
Output voltage
Output current t
AMB
Output current t
AMB
Voltage adjustment range
Ripple
Battery charge current
Approximate backup time
Short-circuit protection SCP
Overload protection OLP
Battery circuit protection SCP and reverse
polarity connection
Surge protection
Overvoltage protection OVP
Excessive discharge protection UVP
Tampering protection system:
- TAMPER – indicating unwanted opening of the
PSU's enclosure
LED indication:
- AC diode indicating AC power status
- AUX diode indicating DC power status at
the PSU output
F1÷F9 fuse
Mechanical parameters (tab. 4)
Dimensions
Fitting battery
Fixation
Net/gross weight
Enclosure
Closing
Connectors
Notes
PSDCB09129C
<30°C
=40°C
W=280, H=292, D+D
W =285, H =296 [+/- 2mm]
1 1
185x170x75mm (WxHxD) max
see figure 3
2.4kg / 2.6kg
Steel plate, DC01 0,7mm colour: RAL 9003
Cheese head screw x 2 (at the front), lock assembly possible
Power supply: Φ0,63-2,50 (AWG 22-10)
OutputsФ0,41÷1,63 (AWG 26-14),
Battery output BAT: 6,3F-2,5
TAMPER output: wires
The enclosure does not adjoin the assembly surface so that cables can be led.
176÷264V AC
1,4A@230V AC
155W max.
83%
11V÷13,8V DC – buffer operation
9,5V÷13,8V DC – battery-assisted operation
9x1A + 1A battery charge - refer to chart 1
9x0,77A + 4A battery charge - refer to chart 1
9x0,74A + 1A battery charge - refer to chart 1
9x0,41A + 4A battery charge - refer to chart 1
12÷14V DC
120mV p-p max.
1A/4A max. / 17Ah (± 5%)
2h 30min
LB9 STRIP
9x F 1A glass fuse
105 ÷ 150% of power supply, automatic recovery
polymer fuse
varistors
>16V (automatic recovery)
U<9,5V (± 5%) – disconnect of connection battery
- microswitch, NC contacts (enclosure closed),
0,5A@50V DC (max.)
- red, normal status – on, failure: off
- green, normal status – on, failure: off
F 1A/250V
=82+8 [+/- 2mm]
1
5