Cleaning Or Replacing Air Inlet Filter; Figure 5-1. Saros Components; Figure 5-2. Remove Cover - Saros 4000 Operator's Manual

Operator Manual
5.3.1 Removing the air inlet cover.
5.3.2 Disconnect power supplies and remove the battery if connected.
5.3.3 Using a Phillips #1 screwdriver, loosen the four captive screws.
5.3.4 Remove cover.
5.3.5 REMOVING AND CLEANING/REPLACING THE AIR INLET FILTER
5.3.6 Gently remove the filter shown in figure 6-3.
5.3.7 If the filter is damaged, replace.
5.3.8 For cleaning, gently wash with warm soapy water. Allow filter to completely dry before re-installing.
5.3.9 Re-install Air Inlet Filter.
9V Battery
(9257-SEQ)
Battery

Figure 5-1. SAROS Components

5.3 CLEANING OR REPLACING AIR INLET FILTER

Figure 5-2. Remove Cover

Inlet Cover Screws
Air Inlet Filter x4 (9291-SEQ)
(9798-SEQ)
Simplified User
Instructions
Label (behind)
Inlet Cover
(9758-SEQ)
Oxygen
Outlet Port
(9764-SEQ)
HEPA
Filter
(4770-SEQ)
MN255-1 C | 27