Saros 4000 Operator's Manual page 25

Operator Manual
Alarm Codes
Pulse Sensitivity
LCD Contrast
Normal Mode
Brightness
Tactical Mode
Brightness
Tactical Mode On / Off
selection
9V Battery Status
Hours of Operation
System Software Part
Number and Revision
Motor Software Part
Number and Revision
Step 7: Begin using the SAROS
NOTE: You will achieve longer operating time on the Battery if you operate in the Pulse Flow Mode.
Step 8: Power off the Device
Press and hold the "ON/OFF" Standby Button for two (2) seconds to power OFF the SAROS.
Format: AC=XXXX
See Alarm Code Table definitions. When more than one alarm code is present, pressing the Increase key will show
the next highest priority code and pressing the Decrease key will show the next lowest priority code.
Format: P SENS = X (where X is the value of 1 thru 3)
Format: LCD CT = X (where X is the value from 1 thru 6)
Format N BRT = X (where X is 1 thru 6)
Selects the LED and LCD backlight Light intensity used in Normal Mode.
Format T BRT= X (where X is 0 thru 6)
Selects the LED and LCD backlight Light intensity used in Tactical Mode.
Format: TACT=ON
Format: TACT=OFF
Format: 9V = GOOD
Format: 9V = RPLC
Format: HR= XXXXX
Format: FW-1 x.y
(x = Major Version, and y = minor Version)
Format: FW-2 x.y
(x = Major Version, and y = minor Version)
Table 4-4. Utility Menu Screens
MN255-1 C | 25