Brother BES-962BC Instruction Manual page 35

For embroidering with tubular square hoop (middle position)
e
1. Attach four hexagon socket head cap screws to each of F table parts R q, M (2 pcs) w, and
L e from the back.
2. Mount the F table parts from L e in order. Insert the bent part (lower) of F table guide UN r
into the guide. Insert the F table rear pin into the hole of F table stopper N t.
3. Adjust F table supports F y in height so as to make the F table parallel with the floor.
4. Tighten all hexagon socket head cap screws u firmly.
u
w
BES-962BC • BES-1262BC
Pin
q
r
Lower by 1 mm
y
Chapter 2 Preparation of Embroidery Machine
t
33