Brother BES-962BC Instruction Manual page 46

Chapter 2 Preparation of Embroidery Machine
3. Pass the thread through the upper hole of the 2nd pretension. Push up the thread guide
tension disc with your finger, and pass it from the left to the lower hole. Wind the thread
clockwise twice around thread breakage pulley e.
4. Pass the thread through the hole of upper thread guide(upper) r. Wind the thread clockwise
once around the rotary tension disc and place it on the spring.
5. Pass the thread through each hole of upper thread guide(middle) t and thread guide y.
6. After passing the thread through the hole of thread guide y, insert the thread into the right
side of the inner thread guide and pass it through the hole of the thread take-up.
7. Bring the thread back to the inner thread guide. Insert the thread into the hole from the upper
section into thread guide A u.
8. Pass the thread through the hole of the needle bar thread guide o and pass it through the
needle eye. Do not pass it through the presser foot. Pass it to presser spring at the front of
lower thread guide i.
BES-1262BC
eThread breakage pulley
rUpper thread
guide (upper)
tUpper thread
guide (middle)
yThread guide
Rotary
tension
disc
Inner thread
guide
uThread
guide A
iLower
thread
guide
oNeedle bar
thread guide
44
q
wThread guide
tension disc
No.2,5,8,11
No.1,4,7,10
Spring
uThread guide A
iLower thread
BES-962BC • BES-1262BC
Needle Bar No.3,6,9,12
guide