MSI J-TX98 R2 Manual page 26


RAS to CAS Delay (2T): The Timing between RAS to CAS delay you can
choice 2T; 3T; 4T; 5T, the default value is 2T.

CAS# Pulse Width (FP) (2T): CAS Pulse width only for Fast Page mode
DRAM you can choice: 2T; 1T. Default value is 2T.

CAS# Pulse Width (EDO): CAS Pulse width only for EDO DRAM, you can
choice: 2T; 1T. Default value is 1T.

RAMW# Assertion Timing (2T): When DRAM write assertion timing when
read cycle followed by write cycle, you can choice: 3T; 2T. Default value is
2T.

CAS Precharge Timing (FP)/CAS Precharge Timing (EDO) (1T/2T): CAS
signal in rising cycle precharge timing, you can choice 1T; 1T/2T, (1T during
burst cycle, 2T for different cycles); 2T.

SDRAM CAS Latency (3T): The Timing of CAS delay in SDRAM Mode, you
can choice: 3T; 2T. Default value is 3T, it depend on SDRAM
 When using Ti 32MB (Double side) DIMM 2 pcs, please must setting
SDRAM CAS Latency: 2T, to make system work stable another setting (3T) it
will occur system unstable.

SDRAM WR Retire Rate (X-2-2-2):
timing , you can choice: X-2-2-2; X-1-1-1. Default value is X-2-2-2.

SDRAM wait state Control (1WS): SDRAM wait state control during
Precharge command, you can choice: 1WS; 0WS. Default value is 1WS.

Enhanced Memory Write (Disabled): Enhanced performance for the Memory
Write and Invalidate of PCI bus command. Default value is Disabled.

Read Prefetch Memory RD (Enabled): Read Prefetch for the Memory Read
of PCI bus command. Default value is Enabled.

CPU to PCI Post Write (3T): CPU to PCI post write rate control you can
choice: 3T; 4T; Disabled. Default value is 3T.

CPU to PCI Burst Mem. WR (Disabled): Default value is Disabled.

ISA Bus Clock Frequency (PCICLK/4): ISA Bus Clock Frequency setting
when Auto configuration is Disabled, you can choice: PCICLK/3; PCICLK/4;
7.159MHz. Default value is setting by Auto configuration.

System BIOS Cacheable/Video BIOS Cacheable (Enabled): Setting system
BIOS/Video BIOS Cacheable for increase performance .

Memory Hole at 15M-16M (Disabled): Memory Address space form 15MB to
16MB setting to ISA expansion cards specifically using.

VGA Shared Memory Size (1MB): To setting VGA shared memory size can
choice: 0.5MB; 1MB; 1.5MB; 2.0MB; 2.5MB; 3.0MB, 3.5MB; 4MB.
When SDRAM write setting delay
25