Table of Contents
Advertisement
IDE Secondary Slave PIO: The default value is Auto.
Auto:
BIOS will automatically detect the Onboard Secondary Slave PCI
IDE HDD Accessing mode.
Mode0~4: Manually set the IDE Accessing mode.
Onboard FDC Controller: The default value Enabled.
Enabled: Enable the Onboard floppy drive interface controller.
Disabled: Disable the Onboard floppy drive interface controller. When use
On-card ISA FDC's controller.
Onboard UART1: This field allows the user to select the serial port. The
default value is Auto.
COM1:
Enable Onboard Serial port 1 and address is 3F8H.
COM2:
Enable Onboard Serial port 1 and address is 2F8H.
COM3:
Enable Onboard Serial port 1 and address is 3E8H.
COM4:
Enable Onboard Serial port 1 and address is 2E8H.
Disabled: Disable Onboard CHIP's Serial port 1.
Onboard UART2: This field allows the user to select the serial port. The
default value is Auto.
COM1:
Enable Onboard Serial port 2 and address is 3F8H.
COM2:
Enable Onboard Serial port 2 and address is 2F8H.
COM3:
Enable Onboard Serial port 2 and address is 3E8H.
COM4:
Enable Onboard Serial port 2 and address is 2E8H.
Disabled: Disable Onboard CHIP's Serial port 2.
Onboard UART 2 Mode: The default setting is Standard.
HPIR:
HP standard mode IR.
ASKIR:
ASK standard mode IR.
IR function duplex:
Half:
Half duplex IR transfer mode in Half Duplex.
Full:
Full duplex IR transfer mode in Full Duplex.
RxD, TxD Active: Select RxD & TxD active signal level.
Onboard Parallel port: This field allows the user to select the LPT port. The
default value is 378H.
378H:
Enable Onboard LPT port and address is 378H.
278H:
Enable Onboard LPT port and address is 278H.
3BCH:
Enable Onboard LPT port and address is 3BCH.
Disabled: Disable Onboard CHIP's LPT port.
32
Advertisement
Table of Contents
