Expansion Cards; External Connectors - MSI J-TX98 R2 Manual

guide. The white dot should point towards the end of the level. The CPU has a
corner pin for three of the four corners, the CPU will only fit in the one orientation
as shown as follow. With the added weight of the CPU fan, no force is required to
insert the CPU. Once completely inserted, hold down on the fan and close the
socket's lever.
IMPORTANT: You must set jumpers SW1 "DIP Switch for CPU Type" on
jumper JP15 "CPU Voltage Selection" on
you install.

2-8 Expansion Cards

First read your expansion card documentation on any hardware and software
settings that may be required to setup your specific card.
Installation Procedure:
1. Read the documentation for your expansion card.
2. Set any necessary jumpers on your expansion card.
3. Remove your computer's cover.
4. Remove the bracket on the slot you intend to use.
5. Carefully align the card's connectors and press firmly.
6. Secure the card on the slot with the screw you remove in step 4.
7. Replace the computer's cover.
8. Setup the BIOS if necessary.
9. Install the necessary software drivers for your expansion card.

2-9 External Connectors

1. Power connector: AT Power Connector (12-pins block): PW1
White Dot
CPU
Lever
Socket 7
11
page 6 depending on the CPU that
Blank
Lock
CPU ZIF Socket 7
page 6 and
Socket 7