MSI J-TX98 R2 Manual page 15

bracket will then be used for pointing devices or other serial devices. See
BIOS configuration of "Onboard Serial Port"
7. Floppy drive Connector (34-pins block): FDD1
This connector supports the provided floppy drive ribbon cable.
connecting the single plug end to motherboard, connect the two plugs at other
end to the floppy drives.
8. Primary IDE Connector (40-pins block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After
connecting the single plug end to motherboard, connect the two plugs at other
end to your hard disk(s). If you install two hard disks, you must configure the
second drive to Slave mode by setting its jumpers accordingly. Please refer to
the documentation of your hard disk for the jumper settings.
9. Secondary IDE Connector (40-pins block): IDE2
This connector connects to the next set of Master and Slave hard disks.
Follow the same procedure described for the primary IDE connector. You
COM 2
Pin 1
COM 1
Pin 1
Serial port COMA and COMB Connector
FDD1
Pin 1
Floppy Drive Connector
Primary IDE Connector
14
After
Pin 1