MSI J-TX98 R2 Manual page 32

Table of Contents

Advertisement

Internal PCI/IDE
IDE Primary Master PIO : Auto
IDE Primary Salve PIO : Auto
IDE Secondary Master PIO : Auto
IDE Secondary Slave PIO : Auto
Primary Master UltraDMA: Auto
Primary Slave UltraDMA: Auto
Secondary Master UltraDMA: Auto
Secondary Slave UltraDMA: Auto
IDE Burst Mode
IDE Data Port Post Write : Enabled
IDE HDD Block Mode
Onboard FDC Controller : Enabled
Onboard UART1
Onboard UART2
Onboard UART 2 Mode
Onboard Parallel Port : 378/IRQ7
NOTE: If you don't use the Onboard IDE connector, than use On-card (PCI or ISA
card) IDE connector. You will set Onboard Primary IDE: Disabled an Onboard
Secondary IDE: Disabled from CHIPSET FEATURES SETUP UTILITY.
The Onboard PCI IDE cable should be equal to or less than 18 inches (45 cm).
IDE HDD Block Mode: The default value is Enabled.
Enabled:
Enabled IDE HDD Block Mode. The HDD transfer rate is better
than Disabled.
Disabled: Disable IDE HDD Block Mode.
IDE Primary Master PIO: The default value is Auto.
Auto:
BIOS will automatically detect the Onboard Primary Master PCI
IDE HDD Accessing mode.
Mode0~4: Manually set the IDE Accessing mode.
IDE Primary Slave PIO: The default value is Auto.
Auto:
BIOS will automatically detect the Onboard Primary Slave PCI
IDE HDD Accessing mode.
Mode0~4: Manually set the IDE Accessing mode.
IDE Secondary Master PIO: The default value is Auto.
Auto:
BIOS will automatically detect the Onboard Secondary Master
PCI IDE HDD Accessing mode.
Mode0~4: Manually set the IDE Accessing mode.
AWARD SOFTWARE, INC.
: Both
: Disabled
: Enabled
: Auto
: Auto
: Standard
Figure 3-9
31
Parallel Port Mode
PS/2 mouse function
USB Controller
USB Keyboard Support : Disabled
Power Button Over Ride : Enabled
Ring Power Up Control : Enabled
Power Up by Alarm
Month Alarm
: NA
Day of Month Alarm
Week Alarm
*** SUN MON TUE WED THU FRI SAT
***
Off Off Off Off Off Off Off
Time (hh:mm:ss) Alarm : 7: 0: 0
Esc: Quit
↑↓→←: Select Item
F1 : Help
Pu/Pd/+/-: Modify
F5 : Old Values (Shift)F2 : Color
F6 : Load BIOS Defaults
F7 : Load Setup Defaults
: Normal
: Enabled
: Enabled
: Enabled
: 0

Advertisement

Table of Contents
loading

Table of Contents