Supervisor/User Password - MSI J-TX98 R2 Manual

NOTE: Parallel Port address is 378H/3BCH that selects the routing of IRQ7 for
LPT1.
Parallel Port address is 278H that selects the routing of IRQ5 LPT1.

Parallel port Mode: This field allows the user to select the parallel port
mode. The default value is ECP + EPP (Normal).
Normal: Standard mode. IBM PC/AT Compatible bidirectional parallel
port.
EPP: Enhanced Parallel Port mode.
ECP: Extended Capabilities Port mode.
EPP+ECP: ECP Mode & EPP Mode.

PS/2 mouse function (Enabled): Setting the function of PS/2 mouse. When
you choice: Disabled, BIOS will release IRQ12 for other device use the
default value is Enabled.

USB Controller (Enabled): Setting the function of USB controller. Default
value is Enabled.

USB Keyboard Support (Disabled): Setting the USB keyboard support
function default value is Disabled. When you want use USB keyboard you
must Enabled it.

Power Button Over Ride (Enabled): Setting the Power Button function when
setting Enabled and press the power button continuos more than 4 sec, will
make the power off.

Ring Power Up Control (Enabled): When setting this item Enabled, and
press the power button to power off. After Ring in the System will auto power
on.

Power Up by Alarm (Disabled): Default value is Disabled, when choice
Enabled you can setting Month Alarm, Day of Month Alarm, Week Alarm,
Time Alarm to setup the time and date to power on the computer.

Power Button Over Ride (Enabled): Setting the Power Button function . In
normal operation set this item Enabled, and press Power Button continuos at
least 4 sec will make computer power off. When Enabled Power Manage and
Enabled this item, push the Power Button. The system will go to suspend
mode, if press the button continuos more than 4 sec, the computer will power
off.

3-9 SUPERVISOR/USER PASSWORD

This item lets you configure the system so that a password is required each time
the system boots or an attempt is made to enter the Setup program (Refer to
33