Table of Contents
Advertisement
Boot Up NumLock Status: The default value is On.
On:
Keypad is number keys.
Off:
Keypad is arrow keys.
Boot UP System Speed: It selects the default system speed-the speed that
the system will run at immediately after power up.
High:
Set the speed to high.
Low:
Set the speed to low.
NOTE: The board default value is LOW in the field. Boot the system to controller turbo
or De-turbo by Onboard (Turbo Switch).
Gate A20 Option: The default value is Fast.
Normal:
The A20 signal is controlled by keyboard controller or chipset
hardware.
Fast:
Default: Fast. The A20 signal is controlled by Port 92 or chipset
specific method.
Memory Parity Check: The default setting is Disable.
Enable:
Allows system to check memory's parity.
Typematic Rate Setting: This determines the typematic rate.
Enabled:
Enable typematic rate and typematic delay programming.
Disabled: Disable typematic rate and typematic delay programming. The
system BIOS will use default value of this 2 items and the default
is controlled by keyboard.
Typematic Rate (Chars/Sec):
6 : 6 characters per second
10 : 10 characters per second
15 : 15 characters per second
24 : 24 characters per second
Typematic Delay (Msec): When holding a key, the time between the first
and second character displayed.
250 : 250 msec
500 : 500 msec
750 : 750 msec
1000 : 1000 msec
8
: 8 characters per second
12 : 12 characters per second
20 : 20 characters per second
30 : 30 characters per second
22
Advertisement
Table of Contents
