Safety Measures - Maxwell MW-1755 Manual Instruction

ENGLISH
THERMOPOT MW-1755
An electric thermopot is intended for boiling
water and maintaining the temperature of hot
water.
DESCRIPTION
Minimal water level mark «Мин.»
1.
Water level scale
2.
Spout for pouring water
3.
Control panel
4.
Reboil button «REBOIL»
5.
Boiling mode indicator «BOILING»
6.
Keep warm indicator «KEEP WARM»
7.
Lid
8.
Lid opening button
9.
Hand pump for water dispensing
10.
Steam release openings
11.
Hand pump mechanical lock «
12.
Maximal water level mark «Макс.»
13.
Carrying handle
14.
Body
15.
Power cord connector
16.
Rotary base
17.
Power cord
18.
ATTENTION!
For additional protection it is reasonable to install
a residual current device (RCD) with nominal
operation current not exceeding 30 mA, to install
RCD, contact a specialist.

SAFETY MEASURES

•
Before using the electric thermopot, read this
instruction manual carefully.
•
Make sure that the operating voltage of the
unit corresponds to the voltage of your mains.
•
The power cord is equipped with a "euro
plug"; plug it into the socket with reliable
grounding contact.
•
To avoid fire, do not use adapters for plug-
ging the unit in.
•
Do not connect or disconnect the power cord
with wet hands, this may cause electric shock
or injuries.
•
When unplugging the unit, always pull the
plug but not the cord.
•
Never leave the operating unit unattended.
•
Do not switch the thermopot on if it is empty.
•
Do not drop or tilt the unit.
•
Use the thermopot only for water boiling;
it is prohibited to heat or boil other liquids
in it.
MW-1755.indd 8
•
Ensure that water level in the thermopot is
not below the «Мин.» mark and not above the
«Макс.» mark.
•
Do not fill the thermopot with water directly
from the faucet; to fill the thermopot use a
suitable bowl.
•
Place the thermopot on a flat dry and stable
surface; do not place the thermopot on the
edge of the table.
•
Do not place the thermopot next to the
walls or close to the kitchen furniture. Place
the thermopot keeping at least 20 cm gap
between the thermopot body and the wall
and at least 30 cm gap above the thermopot.
•
Do not use the unit near heat sources or
open fire.
•
Do not let the power cord hang from the edge
»
of the table and make sure it does not touch
hot or sharp edges of furniture.
•
Do not open the lid and do not pour water out
during boiling.
•
Do not rotate the unit during water pouring.
•
Do not apply excessive effort when closing
the lid. When using the thermopot, make sure
that the lid is closed tightly.
•
Keep your hands away and do not bend over
the steam release openings, it may cause
burns. Do not block the steam release open-
ing with any objects.
•
Do not touch hot surfaces of the thermopot.
•
Be careful while carrying the thermopot filled
with boiling water.
•
Do not carry the thermopot holding it by the
lid opening button.
•
Be careful when pouring out hot water.
•
Remove the lid before draining the remaining
hot water from the thermopot flask.
•
To avoid risk of electric shock, do not
immerse the thermopot, the power cord and
the power plug of the unit into water or other
liquids.
•
Unplug the unit, if you are not using it or
before cleaning.
•
Do not wash the thermopot in a dishwashing
machine.
•
Before taking the unit away for long storage
or before cleaning, unplug it, pour out water
and let the unit cool down and dry.
•
For children's safety reasons do not leave
polyethylene bags used as packaging unat-
tended.
8
18.07.2018 16:47:13