Cleaning And Care - Vitek VT-2631 Manual Instruction

Hide thumbs

Table Of Contents

Table of Contents

Available languages

ENGLISH

Attention! Do not allow children to play with poly-

ethylene bags or packaging film. Danger of suf-

focation!

•

Never use the unit if the power cord or the power

cord plug is damaged, if the unit works improp-

erly or after it was dropped.

•

If the power cord is damaged, it should be

replaced by the manufacturer, a maintenance

service or similar qualified personnel to avoid

danger.

•

Do not attempt to repair the unit. Do not disas-

semble the unit, if any malfunction is detected or

after it was dropped, unplug the unit and apply

to any authorized service center from the con-

tact address list given in the warranty certificate

and on the website www.vitek.ru

•

Transport the unit in the original package only.

•

Keep the unit out of reach of children and dis-

abled persons.

THE UNIT IS INTENDED FOR HOUSEHOLD USE

ONLY. ITS COMMERCIAL USAGE AND USAGE

IN PRODUCTION AREAS AND WORK SPACES IS

PROHIBITED.

BEFORE THE FIRST USE

In case of the unit transportation or storage

under cold (winter) conditions, it is necessary

to keep it for at least three hours at room tem-

perature.

Before switching the unit on for the first time,

–

make sure that the mains voltage corresponds

to the voltage specified on the unit body.

Unpack the press grill and remove all package

–

materials, wipe the grill body with a slightly damp

cloth and then wipe it dry.

Wipe over the grill plates (2, 4) with a slightly

–

damp cloth, and wipe them dry.

Before using the grill apply some vegetable oil on

–

the non-stick coating of the frying plates (2, 4),

spread the oil over the whole surface and wipe

the surplus oil with a paper napkin.

Close the grill, insert the power plug into the

–

socket, switch the unit on, the power indicator

(5) will ignite.

After 5-10 minutes switch off the unit, turn the

–

grill off, and unplug the unit.

Wait until the frying plates (2, 4) cool down com-

–

pletely and remove the remaining vegetable oil

with a paper napkin.

Note: While the first unit operation the heating

elements burn, therefore occurrence of a small

amount of smoke or foreign smell is possible.

It is normal and is not a sign of malfunction.

FOOD COOKING WITH THE GRILL

Place the grill on a flat, stable surface away from

–

sources of moisture, heat and open flame and

with free access to the mains socket.

Do not place and do not use the grill near highly

–

inflammable objects or liquids and objects sub-

ject to thermal deformation.

Use the unit in places with proper ventilation.

–

•

Oil the non-stick coating of frying plates (2, 4)

slightly and close the grill.

•

Make sure that the fat container (1) is properly

installed.

•

Insert the power plug into the socket, the power

indicator (5) will ignite.

•

In about 5-10 minutes the grill plates (2 and 4)

will reach the set temperature, the power indi-

cator (5) will extinguish, at which point you can

proceed to cooking.

•

Take the handle (3) and open the grill.

•

Carefully put the products on the lower frying

plate (2). Avoid getting burns by splashing liq-

uids or fat.

•

You can use the unit as a griddle plate. To do this

take the upper frying plate (3) by the handle (4),

move it down on the products.

Attention! During the operation the frying plates

and the unit body heat up strongly; do not touch

hot surfaces to avoid burns. Do not touch the

unit body with bare hands. Put on thermal pro-

tective potholders.

•

After the products are ready, lift the upper frying

plate (3) by the handle (4).

•

Put the prepared products into an appropri-

ate dish; use wooden or heat-resistant plastic

kitchen tools to remove the products.

•

Close the grill. When the light indicator (5) extin-

guishes, you can continue cooking.

•

Unplug the unit after you finish cooking.

•

Allow your grill to fully cool before cleaning.