Cleaning And Maintenance - Vitek VT-2630 Manual Instruction

Grill-press
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
When the frying plates reach the required
temperature, the indicator (8) will go out and
you can start cooking.
Take the handle (1), press the lock (2) and
open the grill.
Carefully put the products on the lower fry-
ing plate (4). Avoid getting burns by splash-
ing liquids or fat.
You can use the unit as a griddle plate. To do
this take the upper frying plate (3) by the han-
dle (1), move it down on the products.
Attention! During the operation the frying plates
and the unit body heat up strongly; do not touch
hot surfaces to avoid burns.
Do not touch the unit body with bare hands. Use
the thermal protective kitchen tools.
After the products are ready, lift the upper fry-
ing plate (3) by the handle (1).
Put the prepared products into an appropri-
ate dish; use wooden or heat-resistant plastic
kitchen tools to remove the products.
When using the grill for the second time move
the upper frying plate (3) down on the lower
one (4), wait until the plates reach the pre-
set temperature and then you can continue
cooking.
Note: - During the operation the indicator (8) will
go out and light up again periodically, indicating
the heating element switching on and off.
Using the grill as an open cooking unit.
ATTENTION! Open the grill before plugging it in.
Take the handle (1), press the lock (2) and
open the grill.
Make sure that the fat container (5) is installed
to its place.
Cook the products on two frying plates.
After you finish cooking, set the knob (7) to
the position «OFF» and unplug the unit.
Before cleaning the unit wait until it cools
down completely.
ATTENTION!
Do not switch the grill on without the remov-
able frying plates (3, 4) installed.
Always install the fat container (5) during
cooking.
While the frying plates (3, 4) are heating
up, do not open the grill, the frying plates
heat up quicker and more evenly in closed
position.
Be careful: - the grill body heats up strongly
during the operation. To avoid burns do not
IM VT-2630.indd 5
touch hot surfaces, open the grill only by the
handle (1).
Be careful and beware of hot steam emission
from gaps between the frying plates (3, 4).
Keep your hands and other open parts of your
body away from the frying plates (3, 4).
Do not use the grill for defrosting and cook-
ing frozen food.
Do not cook meat with large bones.
Frying time depends on the products used.
Before eating make sure that the food is
cooked through.
Take the products out of the grill right after
cooking; keeping products in the operating
unit for a long time can cause their burning.
Never use sharp metal objects to take the
cooked food out, as they can damage the
non-stick coating of the frying plates (3, 4).
Always use plastic or wooden kitchen tools
suitable for non-stick coatings.

CLEANING AND MAINTENANCE

Clean the grill after every use.
After you finish using the grill, set the knob (7)
to the position «OFF» and unplug the unit.
Open the frying plates (3, 4) and let the unit
cool down to room temperature.
Consequently remove the frying plates (3, 4)
pressing the locks (9, 10).
Remove the remaining food from the frying
plates (3, 4), wash the frying plates (3, 4) with
warm water and neutral detergent, rinse them
and then dry thoroughly.
Clean the grill body with a soft, slightly damp
cloth and then wipe it dry.
Pour out the fat from the fat container (5), wash
the container (5) with warm water and neutral
detergent, rinse and then dry it thoroughly.
Install the frying plates (3, 4) back to theirs
places; to do this, match the ledges on
the frying plates (3, 4) with the grooves on
the rear locks and press alternately on the
front part of the frying plates (3, 4) until the
locks (9, 10) clicking.
Do not use abrasives, solvents or metal sponges
for cleaning the frying plates (3, 4) and the grill
body, as they can damage the non-stick coating
or the outer surface of the grill body.
Never immerse the grill, power cord and cord
plug into water!
ATTENTION! To avoid electric shock, do not
immerse the unit into water or any other liquids.
5
ENGLISH
7/4/19 12:10 PM

Advertisement

Table of Contents
loading

Table of Contents