Table of Contents
Advertisement
Problem
After switching on the
machine, the message
Empty the drip tray and the
waste container
appears
even though they are
both empty.
Neither milk nor milk
froth comes out of the
central spout.
Empty the drip tray and the
waste container
appears
in the display, even
though the drip tray has
been emptied.
Insert the drip tray and the
waste container
appears
in the display even
though both are
installed.
The drip tray or the
grounds container is
too full or runs over
although the drip tray
and the grounds
container were emptied
after each message on
the display.
Frequently Asked Questions
Possible cause and solution
This is not a fault.
When the drip tray and grounds container are
emptied, the internal counter is not reset after the
coffee machine has been switched off.
drip tray and the waste container
even though the drip tray and the grounds container
are not filled to the maximum.
The milk pipework is blocked.
Clean the central spout, taking particular care to
clean the Cappuccinatore and milk pipework
connections carefully with the cleaning brush.
This is not a fault. The drip tray was not properly
removed and / or replaced too quickly.
The drip tray is not correctly installed and is therefore
not detected.
Empty the drip tray and grounds container.
Reassemble all parts and push the drip tray back
as far as it will go in the coffee machine.
This is not a fault.
It is likely that the drip tray and grounds container
were pulled out or the appliance door was opened
without emptying the drip tray and grounds
container. When the drip tray is pulled out or the
appliance door is opened, the internal counter for
emptying the drip tray and the grounds container is
reset.
Remove the drip tray and grounds container from
the machine and empty them.
Empty the
appears in the display
61
Advertisement
Table of Contents
