Battery Installation - Vitek VT-6414 Manual Instruction

ENGLISH
•
For children safety reasons do not leave
polyethylene bags used as a packaging
unattended.
ATTENTION! Do not allow children to play
with polyethylene bags or packaging film.
Danger of suffocation!
•
Do not attempt to repair the unit. Do not
disassemble the unit by yourself, if any
malfunction is detected or after it was
dropped, unplug the unit and apply to any
authorized service center at the contact
addresses given in the warranty certificate
and on the website www.vitek.ru.
•
To avoid damages, transport the unit in the
original package only.
•
Keep the unit in a dry cool place out
of reach of children and disabled persons.
THIS UNIT IS INTENDED FOR HOUSEHOLD
USE ONLY. ITS COMMERCIAL USAGE AND
USAGE IN PRODUCTION AREAS AND WORK
SPACES IS PROHIBITED.
BEFORE THE FIRST USE
After unit transportation or storage under
cold (winter) conditions, it is necessary
to keep it for at least three hours at room
temperature.
– Unpack the unit completely and remove
any package materials and advertising
stickers that prevent the unit operation.
– Check the unit for damages; do not use it
in case of damages.

BATTERY INSTALLATION

Attention! Batteries leakage can cause inju-
ries or damage the unit. To avoid damages,
follow the recommendations specified below:
– insert batteries following the polarity;
– only use new batteries of the type speci-
fied in the instruction manual;
– do not insert the batteries of different
types, new batteries with old ones, bat-
teries of different brands, or rechargeable
batteries of different capacity;
– if the unit is out of use for a lengthy period
of time, it is recommended to remove the
batteries from the main unit and the exter-
nal sensor;
– do not disassemble the batteries; do not
expose them to high temperatures;
– replace the batteries in time.
Notes: Prolonged operation under low or
high temperatures can reduce the voltage
of the external sensor batteries (10), thus
decreasing the sensor's transmission range.
USING THE WEATHER STATION
External sensor (10)
– The main unit (1) can receive 3 data trans-
mission channels from the external sensor
(10). The channel numbers should match
both on the main unit (1) and the external
sensor (10).
– Open the battery compartment lid (11) and
set the data transmission channel tuner
(14) to the channel number "1".
– Insert two «AAA» batteries (not included),
strictly following the polarity, install the
battery compartment lid (11) back to its
place.
Note: - when using the sensor (10) for mea-
suring negative temperatures it is recom-
mended to install alkaline batteries.
– External sensor (10) can be either hanged,
using the Sensor mounting orifice (12), or
installed onto the base. Point the sensor
(10) to the main unit (1).
– Place the sensor (10) in such manner to
avoid getting it exposed to moisture and
direct sunlight.
– Do not install the external sensor (10) in
places with the temperature below -30°С,
at any negative temperatures the battery
capacity significantly decreases, it may
lead to shorter service life of the batter-
ies and shorter data transmission range.
– Do not install the external sensor (10) far-
ther than 50 meters away from the main
unit (1).
– Select a location for the external sensor
with the minimal number of obstacles on
the way of the radio signal from the exter-
nal sensor to the main unit, such as doors,
walls, or furniture; do not install the sensor
near metal objects or electric appliances.
– For the best data reception quality of the
main unit try different positions of the main
4