General Descriptions; Specifications; Explanation Of Technical Specifications - Cebora PW30 Instruction Manual

2

GENERAL DESCRIPTIONS

2.1

Specifications

This device is a current power source produced using inverter technology, with a integral section for automatic regula-
tion of plasma gases, shield for performing the welding plasma process and welding torch cooling control section.
IT MUST NOT BE USED TO DEFROST PIPES, START ENGINES OR CHARGE BATTERIES.
2.2

Explanation of technical specifications.

This device is manufactured according to the following standards: IEC 60974-1 / IEC 60974-10 (CL. A) IEC 60974-3/
IEC 60974-8 /IEC 61000-3-11 / IEC 61000-3-12.
No.
I1
U1
U0
X
I2
EN
U2
Up
1~ 50/60Hz
I1 Max
I1eff
IP21
S
PMAX
QMAX
NOTES: 1-The machine has also been designed for use in environments with a pollution rating of 3. (See IEC 60664).
30/48
Serial number, to be indicated on any request regarding the welding machine.
Single-phase static frequency converter
Maximum current consumed by the
Power source supply voltage.
Secondary open-circuit voltage.
Duty cycle percentage. The duty cycle expresses the percentage of 10 minutes during which the
welding machine can run at a given current without overheating.
Welding current
Secondary voltage with I2 current
High-frequency power-on voltage
50 or 60-Hz single-phase power supply
Max. current consumption at the corresponding current I2 and voltage U2
This is the maximum value of the actual current consumed, considering the duty cycle. This value
usually corresponds to the capacity of the fuse (delayed type). To be used as a protection for the
device.
Degree of housing protection. Grade 1 as the second digit means protection from vertical falling
water, but not suitable for use outdoors in the rain, unless it is protected.
Suitable for use in high-risk environments.
Maximum pressure of gas entering the machine.
Maximum flow for each gas type
Type of gas used
power source.
3301069/A