Advertisement
INTERNAL STATIONS
PROGRAMMING
How to program the M3, M4, M5 and M6 memory
buttons
You can use these buttons to program frequently used numbers.
To program the buttons:
- pick-up the handset
- press
; no tone is heard on the loudspeaker
- press the button you want to program (M3, M4, M5 or M6)
- dial the number on the keypad (max. 24 digits)
- press
; if programming is correct, you hear the actual tone of PABX.
If not, you hear a continuous sharp tone to indicate incorrect program-
ming.
Note: in case of error replace the handset and repeat the program-
ming procedure.
Important:
- if the telephone is connected to the FT105P or FT208P PABX's, you
must dial 0, 81 or 82 before telephone number of the user to access the
external line (i.e. 810548975615); in case of international calls, it is
recommended to insert a pause (by pressing RP) between the
international code and the user number (i.e. 81001RP67859063).
- if the telephone is connected to the FT11D interface you can program
the telephone number directly; in case of international numbers it is
recommended to insert a pause (i.e.001RP678599063).
OPERATION
Answer a call
Pick-up the handset.
Replace the handset after conversation.
Make a call
Pick-up the handset.
Dial the number.
Replace the handset after conversation.
Note. If the telephone is connected to a Farfisa PABX's, you must dial
0, 81 or 82 to access the external line.
Redial of the last call number dialled
Pick-up the handset.
Press RP.
Replace the handset after conversation.
Note. The key RP redials the last call number dialled only if it is the first
button you press after picking-up the handset. If not, this key inserts a
3-sec. pause during dialling.
Intercom function buttons
These functions can be used only if an intercom installation is con-
nected to the PABX or telephone interface.
Pick-up the handset.
Press:
to operate the electric door lock
to activate stair light or other service
to enable intercom conversation
Replace the handset.
Note. When using the FT11D telephone interface you must program
properly the buttons and for correct operations wait for the public
exchanger tone before using them.
Memory buttons
These buttons need to be programmed.
Pick-up the handset.
Press the button associated to the telephone number you want to dial
(M3, M4, M5 or M6).
Replace the handset after conversation.
Ringing volume adjustment
Move the switch located on the bottom of the telephone on the desired
position (OFF, min. and max.).
153
(MT12 - Gb2004)
OFF
MIN.
MAX.
S
T
U
D
I
O
Advertisement
