Raider RD-GBV05 User Manual page 22

22 www.raider.bg
reconnect the spark plug wire.
SPARK ARRESTOR MAINTENANCE
Hard starting or gradual loss of performance can be caused by carbon deposits lodged in the spark
arrestor screen. For maximum performance, the spark arrestor screen should be periodically cleaned
as follows:
Remove the spark plug.
Remove screws from the engine cover, and then gently move the engine cover aside.
Remove the three-spark arrestor retaining screws, and then remove the spark arrestor cover, screen,
gasket, and chamber.
Use a plastic scraper or wire brush to remove carbon deposits from the arrestor screen, chamber, and
cover.
Inspect the screen carefully, and replace any screen that has been perforated, distorted, or is
otherwise unserviceable.
Install the chamber, screen, gasket and cover in the reverse order of disassembly, and then install and
securely tighten the three cover retaining screws.
Install the engine cover, and verify that the fuel line connections are still tightly in place.
Install the engine cover retaining screws in the reverse order of removal, and tighten securely.9. Install
and tighten the spark plug
STORAGE
(30 days or longer)
Never store this product with any fuel remaining in the tank, or carburetor! Your warranty does not
include coverage for damage caused by "stale" or contaminated fuels!
CLEANING Thoroughly clean the machine exterior.
INSPECTION Inspect the entire machine and tubes for damage, including loose or missing
components, and repair as necessary.
FUEL Drain the fuel tank, and then clear the carburetor and lines by running the machine until it stops
from lack of fuel.
LUBRICATION Remove the spark plug, and then pour approximately 1/4-oz of oil into the cylinder
through the spark plug hole. Before reinstalling the spark plug, pull the recoil starter 2 or 3 times to
distribute the oil over the cylinder walls.
AIR CLEANER Remove, clean, and reinstall the filter element as described under "daily
maintenance."
STORAGE Store the machine in a clean, dry,dust-free environment.
INSPECTION Inspect the entire machine and
tubes for damage, including loose or missing
components.
SPARK PLUG Replace the spark plug with a
champion L9T(LD) , gapped to( 0.6~0.7)mm.
FUEL FILTER Use a wire hook to extract the fuel
filter from inside the fuel tank, and then remove
and wash the filter element in clean fuel.Before
reinstalling the filter, inspect the condition of the
fuel line. If damage or deterioration is noted, the
vacuum should be removed from service until it
can be inspected by a trained service technician.
COOLING SYSTEM Remove the engine cover
(as described under "Spark Arrestor"), and use
a wood or plastic scraper and a soft brush to
remove dirt and debris from the cylinder fins and
crankcase.