Raider RD-GBV05 User Manual page 20

20 www.raider.bg
Idle Speed Adjustment Screw(accesssible through cowl louver)
Stopping the engine
Cool the engine by allowing it to run at idle for 2 to 3 minutes
Stop the engine by pulling the ignition switch
Important!
If the engine continues to run with the ignition switch in the off position, stop the engine by pulling the
choke control out to the fully closed position
A clean and unrestricted airflow is essential to your machine's engine performance and durability.
Before attempting any carburetor adjustment, inspect and clean the engine air cleaner as described in
manual.
Using the machine.
As a general rule, try to operate your machine at the lowest throttle setting necessary to get the job
done:
Use low throttle settings when clearing lightweight materials from around lawns or shrubbery.
Use medium to higher throttle settings to move lightweight grass or leaves from parking lots or
walkways.
Use full throttle when moving heavy loads.
Safe operation
Machine noise increases at higher throttle settings! Always use the lowest throttle setting required to
get the job done!
Never operate the blower when visibility is poor.
Never operate the blower if any component parts are damaged, loose, or missing.
Warning!
Before performing any maintenance on this machine, stop the engine and disconnect the spark plug
wire!
Dirty or damaged cooling system components may allow the engine to overheat,
serious engine damage!
Inspect the engine, tank, and hoses for possible fuel leaks, and repair as necessary.
Inspect the engine cooling fins for accumulations of dirt or debris, and clean as necessary.
EVERY 10 HOURS (MORE FREQUENTLY IN DUSTY CONDITIONS)
possibly causing