Safety Advice - Ferroli ECOTRONIC Plus Manual

ECOTRONIC Plus
Table of contents
Safety advice ...................................................................... 2
Technical data and overview of functions ....................... 3
1. Installation .............................................................. 4
1.1 Mounting................................................................. 4
1.2 Electrical connection ............................................. 5
1.2.1 Overview of connections ...................................... 5
1.2.2 Sensors.................................................................... 5
1.2.3 Actuators ................................................................ 6
1.2.4 Bus ........................................................................... 7
1.2.5 Mains connection ................................................... 7
2. Operation and function ......................................... 8
2.1 Buttons for adjustment ......................................... 8
2.2 Control lamp .......................................................... 8
2.3 Menu structure ...................................................... 9
2.4 User code ............................................................... 9
2.5 Menu overview ..................................................... 10

Safety advice

Please pay attention to the following safety advice in order
to avoid danger and damage to people and property.
This product is to be used in accordance with its intended
use only (see page 3).
Please pay attention to the valid local regulations!
Instructions
Attention should be paid to
- the statutory provisions for prevention of industrial acci-
dents,
- the statutory provisions for environmental protection,
- the Health and Safety at Work Act 1974
- Part P of the Building Regulations 2005
- BS7671 Requirements for electrical installations and rele-
vant safety regulations of DIN, EN, DVGW, TRGI, TRF and
VDE.
These instructions are exclusively addressed to authorised
skilled personnel.
- Only qualified electricians should carry out electrical
works.
- Initial installation must be effected by qualified personnel
named by the manufacturer
Errors and technical changes excepted.
2
|
3. Commissioning .................................................... 11
3.1 Commissioning the controller ........................... 11
3.2 Basic systems and hydraulic variants ................. 11
3.3 Function blocks .................................................... 13
3.4 Adjusting the controller step-by-step ................ 15
3.5 Overview of sensor and relay allocation ........... 16
4. Functions and options ......................................... 25
4.1 Menu: Solar ........................................................... 25
4.2 Menu: Arrangement ............................................. 32
4.2.1 Heating circuits .................................................... 34
4.3 Menu: Heat quantity measurement ................... 39
4.4 Menu: Expert ........................................................ 40
4.4 Menu: Manual operation ..................................... 41
5. Accessory ............................................................. 41
6. Troubleshooting ................................................... 43
Imprint ............................................................................. 48
Declaration of conformity
We, Ferroli S.p.A.. declare under our sole responsibility
that our product ECOTRONIC Plus
lowing standards:
EN 55 014-1
EN 60 730-1
According to the regulations of the above directives, the
product is labelled with
89/336/EWG
73/ 23/EWG
Contents of accessory bag:
2 x dowels and screws for wall-mounting
1 x spare fuse T6,3A
11x strain relief and screw
3 x capacitor 4,7 nF for parallel connection when the load
is smaller than 20 W
complies with the fol-
: