Health And Safety - Ferroli NEW CONDENS FS 300 SERIES Instructions For Use Manual

1. GENERAL

Carefully read and follow the instructions contained in
this instruction booklet.

After boiler installation, inform the user regarding its
operation and give him this manual, which is an inte-
gral and essential part of the product and must be kept
with care for future reference.

Installation and maintenance must be carried out by pro-
fessionally qualified personnel, in compliance with the
current regulations and according to the manufacturer's
instructions. Do not carry out any operation on the
sealed control parts.

Incorrect installation or inadequate maintenance can
result in damage or injury. The manufacturer declines
any liability for damage due to errors in installation and
use, or failure to follow the instructions.

Before carrying out any cleaning or maintenance opera-
tion, disconnect the unit from the electrical power sup-
ply using the switch and/or the special cut-off devices.

In case of a fault and/or poor operation, deactivate the
unit and do not try to repair it or directly intervene.
Contact professionally qualified personnel. Any repair/
replacement of the products must only be carried out by
qualified personnel using original replacement parts.
Failure to comply with the above could affect the safety
of the unit.

This unit must only be used for its intended purpose.
Any other use is deemed improper and therefore
hazardous.

The packing materials are potentially hazardous and
must not be left within the reach of children.

The unit must not be used by people (including children)
with limited physical, sensory or mental abilities or with-
out experience and knowledge of it, unless instructed or
supervised in its use by someone responsible for their
safety.

The unit and its accessories must be appropriately dis-
posed of, in compliance with the current regulations.

The images given in this manual are a simplified repre-
sentation of the product. In this representation there
may be slight and insignificant differences with respect
to the product supplied.
HEALTH & SAFETY
The electricity at work regulations,
The manufacturer's notes must NOT be taken, in any
way, as overriding statutory obligations.
.
These appliances are CE certified for
IMPORTANT
safety and performance. It is, therefore, important
that no external control devices, e.g. flue dampers,
economisers etc., are directly connected to these
appliances unless covered by these Installation and
servicing Instructions or as otherwise recommended
by Ferroli Ltd in writing. If in doubt please enquire.
Any direct connection of a control device not
approved by Ferroli Ltd could invalidate the
certification and the normal appliance warranty. It
could also infringe the Gas Safety Regulations and
the above regulations.
Introduction
Dear Customer,
Thank you for choosing the New Condens FS Series, a
floor-standing boiler featuring advanced design, cutting-
edge technology, high reliability and quality construc-
tion. Please read this manual carefully since it provides
important information on safe installation, use and mainte-
nance. New Condens FS Series
low emissions premix condensing heat generator for
heating, running on natural gas and equipped with a micro-
processor control system.
The boiler body consists of a sectional cast aluminium
alloy heat exchanger and a woven mesh premix burn-
1989
.
er in stainless steel, equipped with electronic ignition with
ionisation flame control, modulating speed fan and mod-
ulating gas valve. New Condens FS Series is a heat
generator arranged to operate alone or in cascade.
is a high efficiency,
4