Table of Contents
Advertisement
Manual
3.4.2
Test stand
The connector for the power supply is located on the left side of the device (when standing in front of the control
panel).
Connector for mains
adaptor (12 V / 5.0 A)
3.5
Memory
The recorded data is stored automatically to the volatile memory (RAM) of the force gauge. When you turn off the
device, the data are lost. The force gauge also has a non-volatile EEPROM memory, where the data can be stored as
well, if desired. The data are preserved there, even after rebooting.
Another possibility is using a microSD card. For this purpose, the force gauge has a microSD card slot which is
located at the left side of the device (during normal use of the PCE-PST 1, this is on the top side of the force gauge).
To insert a microSD card, turn off the device and put the card in the slot. Use the pushing element to push the SD
card in, until it snaps into place. Now turn on the device. An SD symbol should appear in the display.
To remove the SD card, turn off the device once again and use the pushing element to push the card further in, until
the holding mechanism is released.
Address:East Room 306,3th Floor,1st Building,Shenhua Industrial Park,Meihua Road, Futian District,Shenzhen City
Tel:0755-32978297
Email:hj@pce-instruments.cn
10
Advertisement
Table of Contents
