info@tursdaletechnicalservices.co.uk Safety Information ......................3 1.1 warnings ........................... 3 1.2. Cautions .......................... 3 Introduction........................3 General Specifications ....................3 Environmental Conditions ..................... 4 Quick Start ........................4 5.1 Unpacking ........................4 5.2 Set Up ..........................4 5.3 Setting the Temperature ....................5 Parts and Controls ......................
info@tursdaletechnicalservices.co.uk 1. Safety Information Use this instrument only as specified in this manual. Otherwise, the protection provided by the instrument may be impaired. Refer to the safety information in Warnings and Cautions. 1.1 warnings BURN HAZARD – DO NOT touch the IR target surface of the unit. The temperature of the IR target surface is the same as the actual temperature shown on the display.
Unpack the calibrator carefully and inspect it for any damage that may have occurred during hipment. If there is shipping damage, notify the carrier immediately. Verify that the following components are present: PCE-IC1 Calibrator Power Cord User’s Guide 5.2 Set Up Place the calibrator on a flat surface with at least 8 inches of free space around the instrument.
info@tursdaletechnicalservices.co.uk Turn on the power to the calibrator by toggling the power switch on. The fan should begin quietly blowing air through the instrument and the controller display should illuminate after 3 seconds. After a brief self-test the controller should begin normal operation. If the unit fails to operate please check the power connection. The heater will start operating to bring the temperature of the calibrator to the set-point temperature and the display will begin to show the actual target temperature.
info@tursdaletechnicalservices.co.uk Power Inlet – At the rear of the calibrator is the removable power cord inlet that plugs into an IEC grounded socket. Caution: Do not plug the unit into 220V if the heater read 110V. This action will cause the fuses to blow and may damage the instrument.
7.2 Turn on the instrument to "ON" button. 7.3 Changing Display Units The PCE-IC1 can display temperature in Celsius or Fahrenheit. The temperature units are shipped from the factory set to Celsius and locked. the unlock way is: Press the button of "SET" and “...
info@tursdaletechnicalservices.co.uk below 100 ºC after measurement , when the temperature is reduced below 100 ºC the user can turn off the power. warning: turning off the power at high temperature will be easy to destroy the calibrator , which should be cooled off by fan.