How To Attach The Weather Protection To The Device - KROHNE OPTIWAVE 7300 Quick Start Manual

OPTIWAVE 7300 C
How to remove the signal converter
• Loosen the housing locking screw 1 with a 5 mm Allen wrench.
• Remove the housing.
• Tighten the housing locking screw 1.
How to attach the signal converter
• Loosen the housing locking screw 1 with a 5 mm Allen wrench.
• Attach the housing to the flange system 2.
• Tighten the housing locking screw 1.

2.9.5 How to attach the weather protection to the device

Equipment needed:
• Device.
• Weather protection (option).
• 10 mm wrench (not supplied).
The overall dimensions of the weather protection are in "Dimensions and weight" in the
handbook.
Figure 2-23: Installation of the weather protection
• Loosen the bracket nuts on the weather protection.
• Remove the bracket.
• Lower the weather protection onto the device.
• Turn the weather protection so that the keyhole points forward.
• Attach the bracket.
• Lift the weather protection to the top of the housing support pillar.
• Hold the weather protection in the correct position and tighten the bracket nuts.
04/2009 - 4000050002 - QS OPTIWAVE 7300 R05 en www.krohne.com
INSTALLATION
2
25