Konica Minolta DRYPRO 832 Operation Manual page 51

The following messages appear in the message display window.
• The film size and type are displayed as values set for the target tray.
2
If there are films or paper trays inside the supply tray, remove them.
3
Check the attachment position of the film regulation pin.
(A) Film regulation pin
mounting hole (14x14 in.)
Guide hole
Film regulation pin
mounting hole
Size of film to be used
14x17 in.
14x14 in.
11x14 in.
Do not place objects on the supply tray or lean on the supply tray
when it is pulled out. Failure to do so could cause fault.
Do not leave allen keys, film regulation pins, screws, or other items
inside the supply tray� Doing so could cause a failure�
The film regulation pins in the four corners of the supply tray are
fixed in place and cannot be changed.
(B) Film regulation pin
mounting hole (11x14 in.)
Attachment position of film regulation pin
None (film regulation pin is not used)
(A)
(B)
51
Film Related Settings
Intermediate Plate
1
2
3
4
5
6
7
8
9
1 0
1 1
1 2