Konica Minolta DRYPRO 832 Operation Manual page 34

3�1 Starting and Shutting Down
This section describes how to start and shut down DRYPRO 832.
Leave the power supply circuit breaker on during normal use.
Power supply circuit breaker
3�1�1 How to Start
First, start Printlink5-IN or console, and then DRYPRO 832. Perform the following steps.
1
Turn on the DRYPRO 832 power supply circuit breaker.
If the power supply circuit breaker is already turned ON, go to the next step.
2
Press the operation switch until a beep sounds (about one second).
Pressing the operation switch again shuts down. In such a case,
press the operation switch again.
Initialization and warm-up of DRYPRO 832 will start. Upon completion of the warm-
up, the machine is ready to print.
Power supply circuit breaker
Operation Switch
34
Operation Switch