Table of Contents
Advertisement
telephone handset of which is connected to the AR570.
The DTMF commands are referred as below (This table is also stated on page 12.)
DTMF Command
1#
2#
3#
4#
5#
6#
7#
00#
*
Automatic
Disconnect
Special function
For example, the control site sends the DTMF commands of 03# to the remote station, the AR570
at the remote site will acquire the live picture and digitize it as image picture immediately.
After that the AR570 at the remote site will send the image picture in the specified operating mode
(In this case, the operating mode is the COLOR FINE) to the remote site over telephone line link.
Acquire Live picture
Transmit Image
Acquire live picture and after that transmit the image
Change of transmission mode to High speed Monaural
Change of transmission mode to Normal speed Monaural
Change of transmission mode to High speed Color
Change of transmission mode to Normal speed Color
Make disconnect the line
Cancel of the received DTMF Control tone. But it is unable to accept
this cancel code after the AR570 entered in the specified Job already
by receiving the # tone.
Automatic disconnect is available by placing 0(=zero) on the front of
the DTMF command of 1#, 2# and 3#.
For example, if you specify the command as 03#, the AR570 will
acquire the live picture and transmit the image to a distant station.
After the transmission is over, the AR570 will make disconnect
automatically .
Cancel of the received DTMF Control tone. But it is unable to accept
this cancel code after the AR570 entered in the specified Job already
by receiving the # tone.
If the DIP SW4 on the AUTO-SW is ON, the DTMF command of 3#
will be released by pressing the TX switch placed on the front panel of
the AR570.
Functions
35
Advertisement
Table of Contents
