Table of Contents
Advertisement
② The HOLD switch should be an OFF position (Down).
③ Turn the POWER switch to ON. The POWER, VOICE and RX LEDs will light.
④ Pick up a handset and make a phone call to establish voice communication with the other end.
Once vice communication is established, place your telephone handset away from the AR570.
If your telephone equipment has mute switch, push it to mute the background noise.
⑤ Push TX switch once. The both VOICE and RX LEDs will turn OFF simultaneously. This
condition indicates that AR570 is now acquiring of the live picture from the video capturing
device (such as video camera). Also, you can see the captured picture on the monitor screen
at this time.
⑥ After acquiring of the picture is completely finished, the AR570 will turn to transmit the image
to the distant station immediately. While transmitting, the TX LED will light.
⑦ If you want to terminate the transmission on the middle way, you can push the RX switch to
execute it. Then the AR570 will stop the transmission and will turn to standby. The VOICE and
RX LEDs will light when the AR570 is in standby.
⑧ At the distant station, first answer the phone call and place telephone handset away from the
AR570. Once the unit start receiving the image, the RX LED start blinks. This indicate that the
unit is receiving image and at the same time the picture can be screen.
⑨ Hang up a handset to make the telephone line OFF.
5-1-2: Radio Equipment
30
Advertisement
Table of Contents
