3-3-2-1: Continuous Transmission (For Only Operation Via Leased Line) - AOR Trans.View AR570 Operating Manual

3-3-2-1: Continuous Transmission (for only operation via leased line)

SW 1 SW 2
OFF OFF
OFF ON
ON ON
ON OFF
The continuos operation for transmission of the image picture is available by using a combination
of the SW1 and SW2 on the AUTO DIP switch. However, this function is only used when you apply
the AR570 into the leased line network.
The time interval will be placed with between the time when the transmission is over and the next
acquiring motion. The setting illustrated above indicates you can transmit the image
continuously with the interval of 5 seconds.
Acquire
To activate the continuos transmission mode, you should the SW4 of the MODE DIP switch ON to
enable the automatic dialing function to ON.
Also, the both transmit and receive stations are synchronized the position of the SW 1 and
SW2 on the AUTO DIP switch to each other when this operation is selected.
The continuos transmission will be activated until the receive station sends the termination signals
to the transmit station. The termination signals will be released when the RX switch on the receive
station is pressed. Once the transmit station receives the termination signals from the receive
station, the link of the line will be disconnected immediately.
Not activate the continuous transmission
Activate the continuous transmission with a 5-second time interval.
Activate the continuous transmission with a 30-second time interval.
Activate the continuous transmission with a 60-second time interval.
Transmit
← ← ← ← Interval→ → → →
Functions
Acquire Transmit
← ← ← ← Interval→ → → →
15