Table of Contents
Advertisement
ACQ (3.5mm dia monaural jack)
This jack is an external input terminal. This is the same function that you push the TX switch by
contacting two terminals. Once the two terminals are connected, the AR570 will immediately
acquire the live picture from the camera of which is connected to the VIDEO IN on the rear panel of
the AR570 and will image the picture onto the memory. After that, the AR570 will transmit the
image to a distant station over radio link or telephone line link under picture mode selected by DIP
switch on the bottom side of the AR570. The job sequences using the ACQ terminals on the
AR570 Telephone version are;
Contacted the terminals→ → → → acquire live picture→ → → → hang up telephone line→ → → → make dialing to the
specified telephone number (Once the line is connected)→ → → → transmit the image→ → → → hang off the
line→ → → → standby
． ． ． ． ． ． ．． ． ．． ． ． ． ． ． ． ． ． ．
Note: In the sequential
． ． ．． ． ． ． ． ． ． ．
the dialing.
The ACQ LED will light while acquiring the picture and off when it is finished. After that, the AR570
will start to transmit the image promptly and the TX LED will also light simultaneously. Once
transmission of the image is over, the AR570 will turn to standby mode and the TX LED will off.
HOLD (Toggle switch)
The HOLD switch activate and deactivate over drown function by new image. If this switch is UP
position, the AR570 will not capture new image. Also, the AR570 will not activate image data
transmission via RS-232C port in case of UP position. The HOLD switch is in UP position, the RX
LED will not illuminate.
VOICE LED
This LED will illuminate in yellow color while no operating of the AR570 together with the radio
transceiver. No available to use voice operation using microphone when this LED is not
illuminated.
． ． ． ． ． ． ． ． ．． ． ． ． ．
． ． ． ．． ． ． ． ．． ． ． ． ．． ． ． ． ． ． ．． ．． ． ．． ． ． ． ． ． ． ． ．． ． ． ． ． ．
functions above
, the AR570 radio version is not activated to make
9
Advertisement
Table of Contents
