Table of Contents
Advertisement
③ Press the RX switch to select the communication speed in the range of
④ The HOLD switch is OFF. Then the setting progress is now completed.
It is normally used the SW 3 at OFF.
SW 4
ON
Activate the automatic dialing transmission. If the SW4 is OFF, this function is
not activated.
The setting illustrated is;
Transmission Mode:
Communication Speed (RS232C)
Automatic Dialing Transmission
3-3-2: Continuous Transmission and DTMF Remote Control Mode (AUTO-SW)
This section of DIP switches has two functions. The SW1 and SW2 use when you want to transmit
the image continuously with a programmed time interval (5, 30 and 60 seconds). The SW3 enables
to control via DTMF tone. The SW4 enables to transmit DTMF tone using the TX switch placed on
the front panel of the AR570.
1200bps, 75Kbps and 115Kbps.
Monaural Mode with Normal Resolution
115Kbps
Enable
14
Advertisement
Table of Contents
