Table of Contents
Advertisement
⑧ The word of "P2" is to program the telephone number as primary. You can see that "0" is
now blinking.
⑨ You can take same processes using the TX and RX switches that you did on the section
of the adjustment of the daytime clock.
⑩ After the telephone number is programmed on the P1 address, downward the HOLD
switch (OFF) to confirm it.
3-5-3: Sender's Name
The sender's name can also be superimposed on the image picture. The sender's name is
determined in among of A to Z and 0 to 9.
⑪ After the P2 is specified at the above sentence, the HOLD switch is ON again. The
following figures will be appeared on the display device.
⑫ You can take same processes using the TX and RX switches that you did on the section
of the adjustment of the daytime clock.
⑬ After the sender's name is programmed, downward the HOLD switches (OFF) to confirm
it.
P2:0
TT:
22
Advertisement
Table of Contents
