3-5-1: Adjust Daytime Clock - AOR Trans.View AR570 Operating Manual

The AR570 has a dedicated daytime clock CPU battery. And also the AR570 can store two
phone numbers (P1 as primary and P2 as secondary) in the memory.
The stored telephone number can be used in the application of a full automatic dialing system for
connection to a distant station via leased line.
The both of them are backed up by a built-in lithium battery (CR2032) for 2 years.

3-5-1: Adjust daytime clock

The formation of the daytime clock consists of MMDDHHMM (HH=24-hour). You can adjust it by
using the TX and RX switches. To adjust the daytime clock, the procedures are as follows:
① Once the AR570 is OFF.
② Connect a display device to the AR570.
③ Place the HOLD switch to upward (ON), and power the AR570 ON while pressing both TX
and RX switches
④ You can see a white screen in the display device momentary and once you release your
finger from the TX and RX switches. Then a daytime clock will be appeared at right lower
corner soon as below.(The figures for the daytime are different from the values depends
on setting at default)
⑤ You can recognize that the first figure is now blinking. This indicates that the first figure is
now ready to adjust.
⑥ You can adjust the first figure in 0 to 1 by pressing the RX switch while it is blinking.
⑦ If the first figure was adjusted, press the TX switch. The second figure will start blinks. The
second figure can be adjusted in 0 to 2 by pressing the RX switch while it is blinking.
⑧ If the second figure was adjusted, the month of the daytime was set at the new value.
⑨ You can press the TX switch. The third figure will start blinks. The third figure can be
adjusted in 0 to 3 by pressing the RX switch while it is blinking.
⑩ If the third figure was adjusted, press the TX switch. The fourth figure will start blinks. The
fourth figure can be adjusted in 0 to 9 by pressing the RX switch while it is blinking.
00-00 00:00
20