Table of Contents
Advertisement
⑪ If the fourth figure was adjusted, the day of the daytime was set at the new value. And
the month and the day of the daytime have been set completely by this adjustment.
⑫ The next step is to adjust the hour and the minute. Press TX switch after the fourth figure
is set. Then the fifth figure will start blinks. You can adjust the hour in 0 to 2 by pressing
the RX switch while it is blinking.
⑬ The fifth figure was adjusted, you can press the TX switch. The sixth figure will start blinks.
You can adjust the sixth figure in 0 to 9 by pressing the RX switch while it is blinking.
⑭ If the sixth figure was adjusted, the hour of the daytime was set at the new value.
⑮ Press the TX switch. The seventh figure will start blinks. You can adjust the seventh figure
in 0 to 5 by pressing the RX switch while it is blinking.
⑯ If the seventh figure was adjusted, press the TX switch. The eighth will start blinks. You
can adjust the eighth figure in 0 to 9 by pressing the RX switch while it is blinking.
⑰ If the eighth figure was adjusted, place the HOLD switch to downward (OFF) to confirm
the new daytime clock.
3-5-2: Program phone number
You can program two telephone numbers (primary and secondary) for the distant station with 15
digits maximum each.
① After the daytime clock was set, the HOLD switch is now placed at OFF position (Down).
② Upward the HOLD switch to program the telephone numbers. Then the following will be
appeared at left lower corner on the screen soon.
③ The word of "P1" is to program the telephone number as primary. You can see that "0" is
now blinking.
④ You can take same processes using the TX and RX switches that you did on the section
of the adjustment of the daytime clock.
⑤ After the telephone number is programmed on the P1 address, downward the HOLD
switch (OFF) to confirm it.
⑥ After the daytime clock was set, the HOLD switch is now placed at OFF position (Down).
⑦ Upward the HOLD switch to program the telephone numbers. Then the following will be
appeared at left lower corner on the screen soon.
P1:0
21
Advertisement
Table of Contents
