Chapter 3 Starting Up And Ending Of Type 3 Software; Starting Up Of Type 3 Software - Daikin Service Checker TYPE 3.1 Instruction Manual

Chapter 3 Starting up and ending of TYPE 3
3.1 Starting up of TYPE 3 software
Procedures
1) Start Service Checker software by start menu.
2) After the Service Checker software is started, the following main menu is displayed.
［Record(F1)］
［Play(F2)］
［Data transfer(F3)］
［Customer data(F4)］ ： Customer data are input and edited (Be sure to input customer ID .)
［SS data(F5)］
［END(F12)］
software
： Press when recording.(Refer to Chapter 4 Recording of operation data)
： Press when monitoring recorded operation data.
(Refer to 5.1 Play of operation data.)
： Recorded operation data and customer data are transferred to a
another folder. (Refer to 5.4 Data transfer.)
Recorded network map data are possible to see here.(Refer to 3.2
Setting of customer data and 5.2 Playing back of network map.)
： SS data are normally input. (Refer to 3.3 Setting of SS data.)
： The TYPE 3 software is ended. (Refer to 3.5 Ending of TYPE 3
software.)
Chapter 3 Starting up and ending of TYPE 3
- 15 -
software