Daikin Service Checker TYPE 3.1 Instruction Manual page 39

system
selection
2.2 Trigger
conditions
setting
(Note)
Since the [Total of expected record file size(KB)] at the right side of [2.1Trigger record
system selection] window and the [Free hard disk area(KB)] at the bottom of the window
are displayed, confirm if the free area is enough in recording the data. However, be
careful to note that if the free hard disk area of the personal computer is more than 2 GB,
values may not be displayed correctly.
(2) Press the [Setting complete(F1)] to return to the [Network Map Display].
(3) When starting the trigger record inspection, press the [Trigger inspection start(F9)]
in the window of the [Network Map Display] to display the [Trigger inspecting] in
red at the upper left in the window. Also the indication of the button is changed to
the [Trigger inspection end(F9)]. When trigger conditions are met to start trigger
recording, the red characters at the upper left in the window are changed to the
[Trigger recording], and also the indication of the button is changed to the [Trigger
record end(F9)].
(4) When ending the [Trigger inspecting] or the [Trigger recording] manually, press the
[Trigger inspection end (F9)] button or the [Trigger record end(F9)] button. After
starting trigger recording, and recording the operation data of a selected system
for the [Record time before and after trigger] set by (1), the trigger recording is
automatically ended.
- 38 -
By placing the cursor in the [System No.] to press the [F12] key, [Recording]
or [No recording] is shifted. The left side of system recording trigger is
marked *.
The [Trigger conditions] can set two groups: the [Trigger condition 1] and
the[Trigger condition 2]. If either group is met to trigger conditions, trigger
will start recording.
・ Within a group, when all the conditions are met to trigger conditions, trigger
will start recording.
In the window example of the previous page , by the [Trigger conditions 1],
the [Thermo ON] is ON and trigger is started, if [Error code] shows error
state, but no other items are related to.
When clicking with the mouse a column of the [Trigger conditions 1] or the
[Trigger conditions 2] in the right side of the [Data item], since the selection
items (OFF/ON/Neglect) are displayed, select applicable ones.
Chapter 4 Recording of operation data