Adjusting The Eq; Bypassing The Eq; Resetting The Eq Gain Controls - Alesis 03D Owner's Manual

Adjusting the EQ

1. Use the [SEL] and [MIXING LAYER] buttons to select a channel. See Mix-
ing Layer on page 31 for more information.
2. Use the [EQ LOW], [LO-MID], [HI-MID], or [HIGH] button to access the
EQ page shown below.
3. Use the [EQ LOW], [LO-MID], [HI-MID], and [HIGH] buttons to select the
EQ parameters and the PARAMETER wheel to adjust them.
Repeated pressing of the [EQ LOW], [LO-MID], [HI-MID], and [HIGH] button cycles
through the gain, frequency, and Q parameters of the respective band, allowing quick
and easy EQ adjustments.
You can also use the cursor buttons to select EQ parameters. If you are using a mouse,
position the mouse cursor over a control, press and hold the left mouse button, and
then drag the mouse.
The following table lists the EQ specs.
Gain
Frequency
HPF, 10.0–0.10
Q
(41 steps),
1. The Low and High gain controls work as filter on/off switches when the HPF and LPF
filters are selected using the Q control.
2. This is the frequency range for sampling rates of 44.1 kHz and 48 kHz. At a sampling
rate of 32 kHz the range is 21 Hz–15.1 kHz (115 steps).

Bypassing the EQ

To bypass the EQ for the selected channel, simply press the [ENTER] button.
Press again to turn the EQ back on. On the EQ page the [ENTER] button can
be used to bypass the EQ regardless of the cursor position. If you are using a
mouse, simply click the EQ ON switch on the EQ page.

Resetting the EQ Gain Controls

To reset the EQ gain controls for the selected channel, press the EQ [HI-MID] and
[HIGH] buttons together. The frequency and Q controls are not reset.
Low Lo-Mid
–18.0 dB to +18.0 dB (0.5 dB steps)
21 Hz–20.1 kHz (1/12 octave steps, 120 steps)
10.0–0.10 (41 steps)
L.SHELF

Adjusting the EQ

Hi-Mid High
1
2
LPF, 10.0–0.10
(41 steps),
H.SHELF
03D—Owner's Manual
47