Alesis 03D Owner's Manual page 265

Message
TC TYPE MISMATCH!
TO HOST: DATA FRAMING ERROR!
TO HOST: DATA OVERRUN!
TO HOST: DATA PARITY ERROR!
TO HOST: RX BUFFER FULL!
TO HOST: TX BUFFER FULL!
WRONG WORD CLOCK!
YGDAI INPUT SYNC ERROR!
Meaning
Timecode that is different from the automix Time Base set-
ting has been input. The automix may not play back cor-
rectly. Review and correct the setting.
An incorrect signal may have been input to the TO HOST
connector.
An incorrect signal may have been input to the TO HOST
connector.
An incorrect signal may have been input to the TO HOST
connector.
The 03D is probably receiving too much MIDI data at the
TO HOST connector.
The 03D is probably transmitting too much MIDI data
from the TO HOST connector.
The received wordclock is not correct and the 03D cannot
synchronize correctly. Select an appropriate wordclock by
reviewing the system connections, or use the AUTO NAVI-
GATE function on the D.in Setup page of the DIO func-
tion.
The digital audio signal connected via the YGDAI card is
not synchronized with the wordclock master. This may
cause noise. Make sure that the device feeding the YGDAI
card inputs is synchronized to the master wordclock. Even
if the sync system is correctly configured, the wordclock
may become unstable until the digital MTR enters chase
mode, and this message may appear. This message can be
disabled by setting the YGDAI IN SYNC CAUTION prefer-
ence to OFF on the Prefer. page of the UTILITY function.
255
Display Messages
03D—Owner's Manual