Alesis 03D Owner's Manual page 258

248
Chapter 19—MIDI
XG Page
The following table lists the XG tone generator parameters that can be controlled from
the 03D.
Channel faders
Display functions
1. Use the [MIDI REMOTE] button to locate the XG page.
2. Set the MIDI Channel to match the device number of the XG tone gen-
erator. See MIDI/HOST Setup on page 233 for more information.
The 03D display shows Reverb, Chorus, Variation, and Pan controls for parts 1 to 8, 9
to 16, 17 to 24, and 25 to 32 in four groups. Use the PART switches to select these
groups. When group 1 to 8 or 9 to 16 is selected, 03D faders correspond to parts 1 to 16,
and when an 03D fader in group 1 to 8 or group 9 to 16 is operated, the corresponding
group is selected on the display. When group 17 to 24 or 25 to 32 is selected, 03D faders
correspond to parts 17 to 32, and when an 03D fader in group 17 to 24 or group 25 to
32 is operated, the corresponding group is selected on the display.
To adjust the reverb, chorus, expression, or pan of a part on the XG tone generator, or
the reverb return, chorus return, variation return, or Master volume, select a control on
the display and use the PARAMETER wheel. The corresponding parameter on the tone
generator changes.
The Connect function can be used to update the 03D's faders and display controls when
the XG tone generator is first connected, turned on, or a parameter is edited manually.
To execute the Connect function, select the CONNECT button, and then press the
[ENTER] button.
If the variation effect on the tone generator is set to Insertion, there will be a switch that
specifies the part to which it will be assigned.
03D—Owner's Manual
03D Control
Part levels
Reverb levels
Chorus levels
Variation levels or Variation Assign switches
Pan
Reverb, Chorus, and Variation return levels
Master volume
XG Tone Generator Parameter