Display Messages - Alesis 03D Owner's Manual

254

Display Messages

AUTOMIX MEMORY FULL!
AUTOMIX REC ABORTED.
AUTOMIX REC STOPPED!
AUTOMIX REC TIME EXCEEDED!
AUTOMIX RUNNING.
BULK: AUTOMIX MEMORY FULL!
BULK: BYTE COUNT MISMATCH!
BULK: CHECK SUM MISMATCH!
BULK: MEMORY PROTECTED!
CANNOT CONNECT!
CANNOT EXECUTE (NO DATA).
CH17–24 ARE DISABLED!
DIGITAL ST IN SYNC ERROR!
FOR EFFECT1 ONLY.
LOW BATTERY!!
MIDI IN: DATA FRAMING ERROR!
MIDI IN: DATA OVERRUN!
MIDI: Rx BUFFER FULL!
MIDI: Tx BUFFER FULL!
NO DATA TO RECALL.
RECALL SAFE DATA CONFLICT!
SOLO READY.
SOLO SLAVE.
TC FRAME JUMP!
03D—Owner's Manual
Message Meaning
The automix memory is full. Delete some unnecessary
data or back up your data to a MIDI data filer.
Automix recording was aborted and the data was dis-
carded. If the automix undo buffer is set to ENABLE, you
can undo the operation.
Automix recording was stopped.
The total recording time for automix has been exceeded.
Cannot operate while automix is recording or playing.
The received Bulk Dump data cannot be stored because
the automix memory is full.
The byte count of the received Bulk Dump data is not cor-
rect.
The check sum of the received Bulk Dump data is not cor-
rect.
The Bulk Dump data cannot be stored because the desti-
nation is write-protected.
Connection could not be made with the device selected
on the MIDI REMOTE page. Check the port setting and
connections.
Cannot execute as no data has been stored.
When a CD8-CS cascade card is installed in the YGDAI
slot, input channels 17–24 are disabled.
The digital audio signal connected via the DIGITAL ST IN
connector is not synchronized with the wordclock master.
This may cause noise. Make sure that the device feeding
the DIGITAL ST IN is synchronized to the master wordclock
or make the DIGITAL ST IN the wordclock source. This
message can be disabled by setting the DIGITAL ST IN
SYNC CAUTION preference to OFF on the Prefer. page of
the UTILITY function.
The selected effect program can be recalled only to
Effect 1.
The internal battery voltage is getting very low. Back up
the setup data (Bulk Dump on page 242), and ask your
dealer to replace the battery.
An incorrect signal may have been input to the MIDI IN.
An incorrect signal may have been input to the MIDI IN.
The 03D is probably receiving too much MIDI data.
The 03D is probably transmitting too much MIDI data.
Cannot recall as no data has been stored.
Some channels are protected by the scene memory recall
safe function. However, the memory you are trying to
recall has different bus and aux pair settings and pan
mode (stereo/surround) settings, so the scene recall could
not be executed.
Solo mode is active. Use the [SEL] buttons to solo chan-
nels.
When the 03D is configured as cascade slave, you cannot
change the solo status. Use the [SOLO] button on the cas-
cade master.
The timecode being received is jumping and dropping
frames. Check the device outputting the timecode.