Table of Contents
Advertisement
OTHER COMMANDS —This switch determines whether or not MIDI data other than
that set using the PROGRAM CHANGE, CONTROL CHANGE, PARAMETER
CHANGE, and REAL TIME MSG. & MTC switches is echoed.
Operation of this echo switch depends on the HOST INTERFACE setting on the
MIDI/HOST page (MIDI/HOST Setup on page 233). When the HOST INTERFACE is
set to STANDARD I/F, this switch affects data echoed from the MIDI IN to the MIDI
OUT. When set to MULTIPORT, however, it affects data echoed from PORT 2 to the
MIDI OUT.
MIDI CHANNEL —These controls are used to select the MIDI Channels that the 03D
uses to transmit and receive MIDI data. The Tx control sets the transmit MIDI Chan-
nel. The Rx control sets the receive MIDI Channel.
The onboard effects processors feature a freeze effect that can be triggered using MIDI
Note On and Off messages received on the Rx Channel. See FREEZE (Effect 2 only) on
page 141 for more information.
DEVICE No. —This control is used to set the Device No., which is used for MIDI Bulk
Dump and Parameter Change System Exclusive messages. When the 03D transmits a
Bulk Dump data request message, the receiving device uses the Device No. to transmit
the requested Bulk Dump data to that 03D. Other 03Ds ignore the Bulk Dump data.
Basically, the Device No. determines the MIDI Channel used for System Exclusive data
transfer. If you are using only one 03D, the Device No. can be set at 1. If you are using
more than one 03D, however, set each 03D to a different Device No.
237
MIDI Setup
03D—Owner's Manual
Advertisement
Table of Contents
