Advertisement
• To change the oven lamp see the
instructions given "Replacing the
oven lamp" paragraph.
• To change the spark generator,
the spark electrodes and the lamp
holder type 2 the work top has to be
removed as indicated in paragraph
"Replacing the taps".
• To change the lamp-holder force
the tabs of blockage and take the
lamp-holder toward the inside of the
oven.
• To change the eventual programming
accessory, the thermostat,
commutators, the switchs and the
microswitchs, , remove the front panel
as indicated in paragraph "Replacing
the taps".
2
1
Fig. 20
Maintenance
Prior to any maintenance work or
changing parts, disconnect the
Fig. 22
1
3
4
appliance from the gas and electricity
power sources.
Replacing the taps
Proceed in the following way when
replacing a tap:
• Remove pan supports, burner heads.
• Unscrew the burner fixing screws
(fig. 22).(four for ultrarapid burner and
two for the other burners)
• Pull out the knobs.
• Unscrew the three fixing screws
(fig. 22) which lock the front panel to
the front frame then slip out from the
upper fixing brackets.
• Unscrew the six fixing screws
(fig. 22) which lock the side profiles
and remove it.
• Unscrew the two fixing screws
(fig. 22) which lock the hob at the back
and remove it.
• Unscrew the nuts
aluminium pipes and pull out the
thermocouple quick connectors
(fig. 24).
• Unscrew the screws
lock the crosspieces.
• Unscrew the screws
unite the the bridles of the taps to the
front frame.
• Make to slip the ramp toward the back
part and unscrew the screws
(fig. 24) in order to free the taps.
ENGLISH
23
1
3
4
2
of the gas
2
3
(fig. 23) which
2
(fig. 23) which
1
1
2
Advertisement
