Advertisement
Oven cavity
Do not spray or wash the thermostat
bulb with acid based products (check
the product label before use).
The manufacturer cannot be held
liable for any damage caused by
incorrect cleaning.
The oven cavity should be cleaned after
each use to remove cooking residuals
and or grease or sugar which, if burnt on
when the oven is used again, will form
deposits or unremovable stains as well as
unpleasant smells.
To maintain the shine of the enamelled
parts, clean them with warm soapy water,
rinse and dry them thoroughly. ALWAYS
wash the accessories used.
How to clean the inner oven door glass
One of the features of our cookers is that the
inner oven door glass can be easily removed
for cleaning without the aid of specialized
personnel. Just open the oven door and
remove the support securing the glass (fig.8).
Caution: This operation can be
done also with the door fitted on
appliance, but in this way, pay
attention that when the glass is
pull upwards, the force of the
hinges can close the door roughly.
LOCK AT LEAST ONE HINGE (fig. 9)
To reassemble the glass,
proceed in the reverse order,
being careful not to pinch your
fingers. (fig. 8A)
Fig. 8
Fig. 8A
MIND YOUR FINGERS
Oven door removal (for certain models)
The oven door can be removed to give
easier access to the oven when cleaning.
To remove, proceed as follows:
• Open the oven door and insert rivet or
nail (R) in the hole (F) of the hinge (fig. 9).
• Partially close the door, forcing it
upwards at the same time to free stop
tooth and hinge sector.
• Once the hinge is free, pull the door forwards
tilting it slightly upwards to free sector.
• To reassemble proceed in the reverse
order, paying attention to the correct
position of sectors.
Fig. 9
Replacing the oven lamp (fig.10)
Ensure the appliance is switched off
before replacing the lamp to avoid the
possibility of electric shock.
In the event one or both oven lamps need
replacing, the new lamps must comply
with the following requisites: 15 W -
230 V~ - 50 Hz - E 14 - and must be
resistant to high temperature (300°C).
Draw out the side guide rails as described
above.Then, remove the glass protection
cap (V) from the bulb socket, lifting it with
a screwdriver placed between the cap and
the oven wall and replace the lamp
the accessories back in reverse order.
1
Fig. 10
ENGLISH
15
. Fit
1
2
Advertisement
