Advertisement
• Adjustable feet, to be fitted to the
appliance, which allow the height of
the cooker to be aligned with other
kitchen furniture (fig. 16).
• Backguard
. If the cookers are
1
equipped with this accessory, leave of
the factory with this particular inserted
inside the packaging. In order to install
the backguard, it is necessary to
loosen the screws
the back of the hob and then to fix the
backgaurd as indicated in figure 17.
Fig. 16
1
Fig. 17
Gas connection
Before connecting the appliance
check that the data on the rating plate
affixed to the cooker, correspond to
those of the gas mains.
A label on the back of this handbook
and at the back of the cooker gives
the appliance adjustment conditions,
that is, the type of gas and operating
pressure.
Once the cooker is installed, check
there are no leaks using a soapy
solution (never a flame).
The appliance's gas inlet fitting is a
threaded 1/2" male cylindrical type,
in compliance with the UNI-ISO
positioned on
2
2
2
228-1 standards. If gas is distributed
through ducts the appliance must be
connected to the gas mains with:
• a rigid steel pipe, in accordance with
standards, whose joints must be made
using threaded fittings in accordance
with the UNI-ISO 7/1 standard. The
use of hemp with suitable adhesives
or Teflon tape as a sealant is allowed.
• copper pipe, in accordance with the
standard, whose joints must be made
using sealed fittings in accordance
with the standard.
• a flexible stainless steel, seamless pipe
in accordance with the standard, with
a maximum 2 metre extension and
seals in accordance with the standard.
• a flexible rubber hose in accordance
with the standard, with an 8 mm
diameter for LPG and 13 mm for
natural gas or town gas, maximum
1500 mm in length, firmly secured to
the hose fitting with a safety clamp as
per the standard.
If the gas is supplied directly from
a gas cylinder, the appliance, fed by a
pressure regulator in accordance with the
standard, must be connected:
• with a copper pipe in accordance
with the standard, whose joints must
be made using sealed fittings in
accordance with the standard.
• with a flexible stainless steel, seamless
pipe in accordance with the standard,
with a maximum 2 metre extension
and seals in accordance with the
standard. We recommend applying
the special adapter to the flexible pipe,
easily found on the market, to facilitate
connection to the pressure regulator's
hose fitting on the cylinder.
• with a flexible rubber hose in
accordance with the standard, with an
8 mm diameter, minimum 400 mm in
length, maximum 1500 mm in length,
firmly secured to the hose fitting with a
safety clamp as per the standard.
Attention! If the appliance is going
to be recessed (class 2 subclass 1),
connect it to the gas supply source
using only flexible stainless steel,
seamless pipes in accordance with
the standard.
ENGLISH
19
Advertisement
